FUEL PUMP(w/ Canister Pump Module) DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.

  • When replacing the fuel filter, replace it together with the fuel suction plate sub-assembly.

A01RI0WC01
*a Tube

PROCEDURE


  1. REMOVE FUEL SENDER GAUGE ASSEMBLY

    Click here

  2. REMOVE FUEL PUMP WITH FILTER ASSEMBLY


    1. A01RKSS

      Disengage the clamp to disconnect the fuel pump harness from the fuel suction plate sub-assembly.

    2. Disconnect the fuel pump harness connector.

    3. A01RIXG

      Using needle nose pliers, remove the E-ring from the fuel suction plate shaft.

    4. A01RLVB

      Disengage the claw and clamp and disconnect the fuel pump filter hose from the No. 1 fuel sub-tank.

    5. A01RILL

      Disengage the 2 claws and remove the fuel filter and fuel pump with filter assembly from the No. 1 fuel sub-tank.

      Note

      Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.

      Click here

    6. A01RIEL

      Remove the 2 springs from the fuel suction plate shafts.

    7. A01RJ4IC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.

    8. A01RI6DC03
      *a Fuel Filter
      *b Suction filter
      *c Tube
      *d Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump with filter assembly from the fuel filter.

      Note


      • Do not damage the fuel filter or suction filter.

      • Do not remove the suction filter from the fuel pump with filter assembly.

      • Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.

        Click here

    9. A01RIB2

      Disconnect the fuel pump harness connector to remove the fuel pump harness from the fuel pump with filter assembly.

    10. A01RLRCC02
      *1 O-ring
      *2 Fuel Pump Spacer
      *a 5.0 mm (0.197 in.)

      Remove the O-ring and fuel pump spacer from the fuel pump with filter assembly.

      Note

      Be careful not to damage the sealing surface.

      Tech Tips

      If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm (0.0394 in.) diameter) that is formed as shown in the illustration.