HV BATTERY THERMISTOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid battery thermistor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

CAUTION:


  • B004PF2

    Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

    Click here

  • B004Q03

    To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE HV BATTERY JUNCTION BLOCK ASSEMBLY

    Click here

  3. REMOVE NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY

    CAUTION:

    Be sure to wear insulated gloves and protective goggles.


    1. B004Q8I

      Remove the 4 nuts.

    2. B004R01C03
      *1 No. 1 Hybrid Battery Shield Sub-assembly
      *2 No. 2 Hybrid Battery Shield Sub-assembly
      B004PRK Pull Back

      Pull back the No. 2 hybrid battery shield sub-assembly and remove the No. 1 hybrid battery shield sub-assembly from the HV battery.

      Tech Tips

      Pull back the No. 2 hybrid battery shield sub-assembly until it is separated from the stud bolt of the No. 1 hybrid battery shield sub-assembly.

  4. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT

    CAUTION:

    Be sure to wear insulated gloves and protective goggles.


    1. B004QI3

      Disengage the claw of hybrid battery thermistor (sensor portion) and disconnect the hybrid battery thermistor from the No. 1 hybrid battery intake duct.

    2. Disengage the claw to remove the No. 1 hybrid battery intake duct from the HV battery.

  5. REMOVE HYBRID BATTERY THERMISTOR

    CAUTION:

    Be sure to wear insulated gloves and protective goggles.


    1. B004Q7V

      Disengage the clamp.

    2. B004P5K

      Disengage the 2 claws and remove the No. 1 hybrid battery packing from the HV battery.

    3. B004QUV

      Disengage the clamp.

    4. Disconnect the battery voltage sensor connector.

    5. B004QOT

      Disengage the 4 clamps.

    6. B004QU3

      Disengage the 3 claws of the hybrid battery thermistor (sensor portions) and remove the hybrid battery thermistor from the HV battery.