IGNITION COIL AND SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of ignition coil assembly

  • Replacement of spark plug

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here w/ Canister Pump Module

Click here w/o Canister Pump Module

PROCEDURE


  1. REMOVE FRONT WIPER ARM HEAD CAP (for LHD, RHD Type A)

    Click here

  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for LHD, RHD Type A)

    Click here

  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for LHD, RHD Type A)

    Click here

  4. REMOVE COWL WATER EXTRACT SHIELD LH (for LHD, RHD Type A)

    Click here

  5. REMOVE COWL WATER EXTRACT SHIELD RH (for LHD, RHD Type A)

    Click here

  6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for LHD, RHD Type A)

    Click here

  7. SEPARATE CENTER NO. 1 COWL TOP VENTILATOR LOUVER (for RHD Type B)


    1. B004PMDC01
      B004PFI Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. B004QLL

      Disengage the 3 claws and separate the hood to cowl top seal from the cowl top ventilator louver.

    3. B004PZK

      Disengage the 2 claws and 8 guides and separate the center No. 1 cowl top ventilator louver.

  8. REMOVE IGNITION COIL ASSEMBLY


    1. B004OUP

      Disconnect the 4 ignition coil assembly connectors.

    2. B004Q3U

      Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.

      Note

      If an ignition coil assembly has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.

  9. REMOVE SPARK PLUG


    1. B004OJP

      Remove the 4 spark plugs from the cylinder head sub-assembly.

      Note

      If a spark plug has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.