ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Flow Shutting Valve (Water Valve))


    1. Apply a light coat of engine coolant to the O-ring of the No. 2 engine coolant temperature sensor.

    2. Install the No. 2 engine coolant temperature sensor to the No. 2 water by-pass pipe with the clip.

      Note


      • If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.

      • If reusing the No. 2 engine coolant temperature sensor, be sure to inspect the O-ring.

      • Make sure that the O-ring is not cracked or moved out of place when installing the No. 2 engine coolant temperature sensor.

    3. Connect the No. 2 engine coolant temperature sensor connector.

  2. INSTALL INVERTER WITH CONVERTER ASSEMBLY (w/ Flow Shutting Valve (Water Valve))

    Click here

  3. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.



    1. Install a new gasket to the engine coolant temperature sensor.

    2. A01VBPEN01

      Using SST, install the engine coolant temperature sensor to the water outlet.

      SST
      09817-33191

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.

      Torque:
      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

    3. Connect the engine coolant temperature sensor connector.

  4. INSTALL EGR PIPE ASSEMBLY

    Click here

  5. ADD ENGINE COOLANT (for Engine)

    Click here

  6. INSPECT FOR COOLANT LEAK (for Engine)

    Click here

  7. INSTALL REAR MOTOR UNDER COVER LH

    Click here

  8. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  9. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.