WHEEL OPENING MOULDING(for Front) DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE NO. 1 MOULDING TAPE


    1. A01CQP0

      Remove the No. 1 moulding tape (double-sided tape).

      Tech Tips

      Do not pull on the No. 1 moulding tape (double-sided tape). Instead, roll the tape up with your finger to remove it cleanly.

      A01CQE3

    2. Using non-residue solvent and a cloth, wipe off any No. 1 moulding tape (double-sided tape) remaining on the front fender moulding sub-assembly LH.

      Tech Tips

      If any No. 1 moulding tape (double-sided tape) remains in the groove of the front fender moulding sub-assembly LH, use a thin-bladed screwdriver to remove it.

  2. REMOVE NO. 2 MOULDING TAPE


    1. A01CNFS

      Remove the No. 2 moulding tape (double-sided tape).

      Tech Tips

      Do not pull on the No. 2 moulding tape (double-sided tape). Instead, roll the tape up with your finger to remove it cleanly.

      A01CQE3

    2. Using non-residue solvent and a cloth, wipe off any No. 2 moulding tape (double-sided tape) remaining on the front fender moulding sub-assembly LH.

      Tech Tips

      If any No. 2 moulding tape (double-sided tape) remains in the groove of the front fender moulding sub-assembly LH, use a thin-bladed screwdriver to remove it.