SIDE MUDGUARD REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL NO. 3 MOULDING TAPE


    1. Clean the No. 3 moulding tape installation surface.


      1. When reusing the side mudguard LH, remove the double-sided tape remaining on the No. 3 moulding tape installation surface.

        Note


        • Installing the No. 3 moulding tape with some double-sided tape remaining may cause poor adhesion.

        • Removing with a screwdriver, etc. may cause damage or poor adhesion.

      2. Clean the No. 3 moulding tape installation surface with a non-residue solvent.

      3. Apply primer to the No. 3 moulding tape installation area on the side mudguard LH.

        Note

        Do not apply too much primer.

    2. Remove the peeling paper on a new No. 3 moulding tape while making sure not to touch the adhesional surface.

    3. A01CRH8C01
      *1 Mark-off Line
      *a 3.0 mm (0.118 in.)
      *b 1.0 mm (0.0394 in.)

      Install a new No. 3 moulding tape in the position shown in the illustration.

      Note


      • Press the double-sided tape on the No. 3 moulding tape firmly to attach.

      • After the primer dries (3 minutes or more), install the No. 3 moulding tape.

      • After applying primer, reapply primer after 24 hours elapse.