SIDE MUDGUARD REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE SIDE MUDGUARD SUB-ASSEMBLY LH

    Tech Tips

    When removing the side mudguard sub-assembly LH, if the No. 3 moulding tape (double-sided tape) is difficult to remove, heat the adhesive of the side mudguard sub-assembly LH using a heat light.

    Standard
    Item Temperature
    Side Mudguard Sub-assembly LH 40 to 60°C (104 to 140°F)

    Note

    Do not heat the side mudguard sub-assembly LH excessively.


    1. A01CONC

      Remove the screw.

    2. Remove the clip.

    3. Using a clip remover, remove the grommet.

    4. A01COABC01
      *1 Protective Tape

      Put protective tape around the side mudguard sub-assembly LH.

    5. A01CPA6C01
      *1 No. 3 Moulding Tape (Double-sided Tape)
      B002HVY Direction to Pull

      Detach the 2 clips and remove the side mudguard sub-assembly LH.