FRONT DOOR OUTSIDE MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE FRONT DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH

    Tech Tips

    When removing the front door lower outside moulding sub-assembly LH, heat the front door panel and front door lower outside moulding sub-assembly LH using a heat light.

    Standard
    Item Temperature
    Front Door Panel 40 to 60°C (104 to 140°F)
    Front Door Lower Outside Moulding Sub-assembly LH 20 to 30°C (68 to 86°F)

    Note

    Do not heat the front door panel and front door lower outside moulding sub-assembly LH excessively.


    1. Put protective tape around the front door lower outside moulding sub-assembly LH.

      A01CN0LC01
      *1 Protective Tape - -
    2. A01CRH9

      Using moulding remover D, detach the 6 claws.

    3. A01CNTT

      Remove the hole cover.

    4. Remove the nut.

    5. A01CNDVC01
      *1 Double-sided Tape

      Using moulding remover D, detach the 7 clips and remove the front door lower outside moulding sub-assembly LH.