VEHICLE APPROACHING SPEAKER SWITCH INSPECTION

PROCEDURE


  1. INSPECT NO. 2 COMBINATION SWITCH ASSEMBLY(VEHICLE APPROACHING SPEAKER SWITCH)


    1. Remove the No. 2 combination switch assembly.

      Click here

    2. Check the resistance.


      1. A01O8J9C03
        *a

        Component without harness connected

        (No. 2 Combination Switch Assembly (Vehicle Approaching Speaker Switch))

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        5 (IG) - 17 (ECU) Switch off 10 kΩ or higher
        Switch on Below 1 Ω

        If the result is not as specified, replace the vehicle approaching speaker switch.

    3. Inspect the illumination operation.


      1. Apply auxiliary battery voltage to the vehicle approaching speaker switch connector, and check that the vehicle approaching speaker switch LED illuminates.

        OK
        Measurement Condition Specified Condition

        Auxiliary battery positive (+) → Terminal 8 (ILL+)

        Auxiliary battery negative (-) → Terminal 15 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the vehicle approaching speaker switch.