HEIGHT CONTROL SENSOR INSTALLATION

PROCEDURE

1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

   Note

   If the rear height control sensor sub-assembly has been dropped, replace it with a new one.

   
   

   1. Attach the 2 hooks to install the rear height control sensor sub-assembly.

   2. Install the 2 bolts.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

   3. Connect the connector.

2. PERFORM INITIALIZATION

   Note

   If any of the work in the table below has been performed, vehicle information registration and initialization of the headlight light control ECU sub-assembly LH is necessary.

   Click here

   Performed Work or System Condition	Necessary Procedures
   Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components	Initialization of the headlight light control ECU sub-assembly LH

3. INSPECT AUTOMATIC LIGHT CONTROL SYSTEM

   Click here

4. INSPECT HEADLIGHT AIMING

   for LED Headlight:

   Click here

   for Halogen Headlight and LED Headlight:

   Click here