AHS ECU INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.

  • Do not reuse parts which have reduced fastening ability due to thread damage.

  • When installing components, make sure that the wire harness is not pinched or pulled.

  • Do not use solvent to clean components. Only clean them with a dry cloth.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL LIGHT CONTROL LED ECU LH

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    • Perform work using clean rubber gloves.

    • Do not touch the headlight unit assembly LH with bare hands.

    • Do not allow metallic surfaces to become dirty, as such surfaces become damaged even if they are only lightly wiped with a soft cloth.

    • If there are fingerprints on the inner surface of the lens, lightly wiped with a soft cloth.

    • Do not use solvent to clean components. Only clean them with a dry cloth.

    SST
    09890-47010   ( 09891-04010, 09891-04020, 09891-04030, 09891-04040 )

    1. Install the light control LED ECU LH with the screw.

    2. Connect the 2 connectors.

    3. Install the headlight bezel with the 3 screws.

  2. INSTALL HEADLIGHT LENS GASKET

    Click here

  3. INSTALL HEADLIGHT LENS LH

    Click here

  4. INSTALL HEADLIGHT ASSEMBLY LH

    Click here