REAR COMBINATION LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE TONNEAU COVER ASSEMBLY

    Click here

  3. REMOVE DECK BOARD ASSEMBLY

    Click here

  4. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  5. REMOVE SPARE TIRE (w/ Spare Tire)

    Click here

  6. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY

    Click here

  8. REMOVE DECK FLOOR BOX LH (w/o Spare Tire)

    Click here

  9. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  10. REMOVE DECK FLOOR BOX RH (w/o Spare Tire)

    Click here

  11. REMOVE DECK FLOOR BOX RH (w/ Spare Tire)

    Click here

  12. REMOVE REAR FLOOR FINISH PLATE

    Click here

  13. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  14. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  15. DISCONNECT DECK TRIM SIDE PANEL ASSEMBLY LH


    1. Disconnect the rear side of the deck trim side panel assembly LH so that the connector of the rear combination light assembly LH can be disconnected.

      Click here

  16. REMOVE REAR COMBINATION LIGHT COVER LH


    1. B002L1QC02
      B002JLO Protective Tape

      Apply protective tape as shown in the illustration.

    2. Using a screwdriver, detach the 7 claws and remove the rear combination light cover LH.

      Tech Tips

      Tape the screwdriver tip before use.

  17. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH


    1. B002KRE

      Place your hand between the deck trim side panel assembly LH and the body to disconnect the connector.

    2. B002IUM

      Remove the 2 bolts.

    3. B002KPM

      Detach the wire harness clamp.

    4. Disconnect the grommet and pull out the wire harness.

    5. B002IOYC01
      B002JLO Protective Tape

      Apply protective tape around the rear combination light assembly LH.

    6. Pull the rear combination light assembly LH towards the rear of the vehicle to detach the pin and 3 guides and remove it.

      Note

      Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.

  18. REMOVE REAR COMBINATION LIGHT RETAINER LH


    1. B002JEN

      Remove the bolt and rear combination light retainer LH.