FOG LIGHT ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FOG LIGHT ASSEMBLY LH


    1. A01CQ2IC01
      *a

      Component without harness connected

      (Fog Light Assembly LH)

      Apply auxiliary battery voltage to the connector and check the light illumination condition.

      OK
      Condition Specified Condition

      Auxiliary battery positive (+) → A28-2 (B)

      Auxiliary battery negative (-) → A28-3 (CRPL)

      Auxiliary battery negative (-) → A28-4 (E)

      		 A and B illuminates

      Auxiliary battery positive (+) → A28-1 (B)

      Auxiliary battery positive (+) → A28-2 (B)

      Auxiliary battery negative (-) → A28-3 (CRPL)

      Auxiliary battery negative (-) → A28-4 (E)

      		 A and B and C illuminates

      Auxiliary battery positive (+) → A28-1 (B)

      Auxiliary battery negative (-) → A28-4 (E)

      		 B and C illuminates

      If the result is not as specified, replace the fog light assembly LH.

  2. INSPECT FOG LIGHT ASSEMBLY RH


    1. A01CO8BC01
      *a

      Component without harness connected

      (Fog Light Assembly RH)

      Apply auxiliary battery voltage to the connector and check the light illumination condition.

      OK
      Condition Specified Condition

      Auxiliary battery positive (+) → A29-2 (B)

      Auxiliary battery negative (-) → A29-3 (CRPR)

      Auxiliary battery negative (-) → A29-4 (E)

      		 A and B illuminates

      Auxiliary battery positive (+) → A29-1 (B)

      Auxiliary battery positive (+) → A29-2 (B)

      Auxiliary battery negative (-) → A29-3 (CRPR)

      Auxiliary battery negative (-) → A29-4 (E)

      		 A and B and C illuminates

      Auxiliary battery positive (+) → A29-1 (B)

      Auxiliary battery negative (-) → A29-4 (E)

      		 B and C illuminates

      If the result is not as specified, replace the fog light assembly RH.