DESCRIPTION
The headlight ECU sub-assembly controls the headlight leveling motor.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
PROCEDURE
PERFORM ACTIVE TEST USING GTS (LEVELING MOTOR)
Using the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor | Operates the headlight leveling motor | Up, Down or Stop | Perform with the vehicle stopped, power switch on (READY) and low beam headlights illuminated. |
| Tester Display |
|---|
| Drive The Leveling Motor |
| Result | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| A |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
| C |
|
INSPECT HEADLIGHT UNIT ASSEMBLY LH Click here |
| B |
|
INSPECT HEADLIGHT UNIT ASSEMBLY RH
| *a | Component without harness connected (Headlight Leveling Motor RH) |
| *b | Component without harness connected (Headlight Control ECU Sub-assembly RH) |
Remove the headlight leveling motor RH.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE HEADLIGHT UNIT ASSEMBLY RH Click here |
| OK |
|
CHECK HEADLIGHT LEVELING MOTOR RH
Replace the headlight leveling motor RH with a new or known good one.
Using the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor | Operates the headlight leveling motor | Up, Down or Stop | Perform with the vehicle stopped, power switch on (READY) and low beam headlights illuminated. |
| Tester Display |
|---|
| Drive The Leveling Motor |
| OK |
|---|
| The Active Test is performed normally. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (HEADLIGHT LEVELING MOTOR RH WAS DEFECTIVE) |
| NG |
|
REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH Click here |
INSPECT HEADLIGHT UNIT ASSEMBLY LH
| *a | Component without harness connected (Headlight Leveling Motor LH) |
| *b | Component without harness connected (Headlight Control ECU Sub-assembly LH) |
Remove the headlight leveling motor LH.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE HEADLIGHT UNIT ASSEMBLY LH Click here |
| OK |
|
CHECK HEADLIGHT LEVELING MOTOR LH
Replace the headlight leveling motor LH with a new or known good one.
Using the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor | Operates the headlight leveling motor | Up, Down or Stop | Perform with the vehicle stopped, power switch on (READY) and low beam headlights illuminated. |
| Tester Display |
|---|
| Drive The Leveling Motor |
| OK |
|---|
| The Active Test is performed normally. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (HEADLIGHT LEVELING MOTOR LH WAS DEFECTIVE) |
| NG |
|
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH Click here REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH Click here |