PROCEDURE
INSTALL HEADLIGHT CLEANER WASHER BRACKET
Tech Tips
Use the same procedure for both headlight cleaner washer brackets.
Clean the front bumper cover surface.
Remove the double-sided tape from the front bumper cover.
Wipe off any tape adhesive residue with cleaner.
|
Primer |
Apply primer.
Using a brush or felt, apply primer or equivalent to the retainer installation area.
Note
Use a clean brush or felt.
Do not allow primer to contact the front surface of the front bumper cover.
Do not touch the front bumper cover until the primer has dried.
| Recommended drying time |
|---|
| 10 minutes or more {23°C (73°F)} |
Peel off the release paper from the headlight cleaner washer bracket.
| *a | Protrusion of the mark |
Align the headlight cleaner washer bracket with the mark on the front bumper cover and install it as shown in the illustration.
Note
The double-sided tape of a headlight cleaner washer bracket will deteriorate if it is detached. Make sure to replace the headlight cleaner washer bracket with a new one when reattachment is necessary.
Tech Tips
Press on the areas indicated by the arrows in the illustration and install the headlight cleaner washer bracket firmly so that there is no clearance between the headlight cleaner washer bracket and front bumper cover.
INSTALL NO. 2 HEADLIGHT CLEANER HOSE
Attach the 8 clamps to install the No. 2 headlight cleaner hose.
INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH
Attach the claw to install the headlight washer actuator sub-assembly RH.
Attach the claw to connect the headlight cleaner hose.
INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH
Tech Tips
Use the same procedure described for the RH side.
INSTALL FRONT BUMPER ASSEMBLY
Install the front bumper assembly.
for Sport Package:
except Sport Package: