KICK SENSOR REMOVAL

PROCEDURE


  1. REMOVE REAR BUMPER COVER

    Click here

  2. REMOVE KICK DOOR CONTROL BRACKET


    1. B002J6I

      Disconnect the connector and detach the 2 wire harness clamps.

      Note

      Do not touch the terminal of the kick door control sensor connector.

    2. B002HR8

      Remove the screw.

    3. Remove the 3 outside moulding retainers.

    4. Detach the 3 guides and remove the kick door control bracket together with the kick door control sensor as shown in the illustration.

      B002KE5C02
      *1 Outside Moulding Retainer - -

  3. REMOVE KICK DOOR CONTROL SENSOR


    1. Detach the 16 claws in the order shown in the illustration and disconnect the antenna.

      B002JNDN02
    2. B002J95C03
      *a Wire (red)

      Detach the clamp and disconnect the wire (red) from the kick door control bracket.

      Note


      • Do not pull strongly on the wire.

      • Do not twist the wire.

    3. B002KTY

      Detach the 2 claws and guide, and remove the kick door control sensor from the kick door control bracket as shown in the illustration.

      Note


      • Do not subject the kick door control sensor to strong impacts or force, and do not drop it.

      • Do not reuse a kick door control sensor which has been subjected to an impact or dropped.