POWER BACK DOOR CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT BACK DOOR CONTROL SWITCH


    1. Check the resistance.


      1. B002JVTC02
        *a

        Component without harness connected

        (Back Door Control Switch)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        5 (CLS) - 2 (E) Switch off 10 kΩ or higher
        5 (CLS) - 2 (E) Switch on Below 1 Ω

        If the result is not as specified, replace the back door control switch.

    2. Inspect the illumination operation.


      1. Apply battery voltage to the power back door main switch connector, and check that the back door control switch LED illuminates.

        OK
        Measurement Condition Specified Condition

        6 (ILL+) - Battery positive (+)

        1 (ILL-) - Battery negative (-)

        		 LED illuminates

        If the result is not as specified, replace the back door control switch.