HOOD ADJUSTMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Centering bolts are used to mount the hood hinge to the vehicle body and hood. The hood cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts (with washers) when making adjustments.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

B002JPOC17
*1 Centering Bolt
*2 Standard Bolt

PROCEDURE


  1. INSPECT HOOD SUB-ASSEMBLY

    Click here

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  3. REMOVE HOOD LOCK CONTROL CABLE COVER (for RHD, w/ Cover)

    Click here

  4. ADJUST HOOD SUB-ASSEMBLY


    1. B002L18

      Adjust the hood position.


      1. Loosen the 4 hinge bolts on the hood and adjust the hood position.

      2. Move the hood and adjust the clearance between the hood and front fender.

      3. Tighten the 4 hinge bolts on the hood after the adjustment.

        Torque:
        13 N*m  { 133 kgf*cm, 9.6 ft.*lbf }
    2. B002HIO

      Adjust the cushion rubber so that the hood and fender are aligned.

      Tech Tips

      Raise or lower the front end of the hood by turning the cushion rubber.

    3. B002KNS

      Adjust the hood lock.


      1. Loosen the 3 bolts.

      2. Adjust the hood lock position so that the striker can enter it smoothly.

      3. Tighten the 3 bolts after the adjustment.

        Torque:
        8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  5. INSTALL HOOD LOCK CONTROL CABLE COVER (for RHD, w/ Cover)

    Click here

  6. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here