SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY (SLIDING ROOF SWITCH ASSEMBLY)


    1. A01CNHWC02
      *a

      Component without harness connected

      (Map Light Assembly (Sliding Roof Switch Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      11 (OPN) - 19 (GND) Open switch is pressed Below 1 Ω
      Open switch is not pressed 10 kΩ or higher
      12 (CLS) - 19 (GND) Close switch is pressed Below 1 Ω
      Close switch is not pressed 10 kΩ or higher
      23 (UP) - 19 (GND) Up switch is pressed Below 1 Ω
      Up switch is not pressed 10 kΩ or higher
      24 (DOWN) - 19 (GND) Down switch is pressed Below 1 Ω
      Down switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the map light assembly (sliding roof switch assembly).