SLIDING ROOF HOUSING REASSEMBLY

PROCEDURE


  1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    1. Attach the 2 guides as shown in the illustration to install the roof wind deflector panel sub-assembly.

      A01CR1E

    2. Attach the 2 springs as shown in the illustration.

      A01CR3AC02
      *a Spring - -

      Note

      Make sure that the springs are securely installed.

    3. A01CP2C

      Hold down the roof wind deflector panel sub-assembly.

    4. A01CQL1

      Slide the sliding roof drive cable to the end.

      Tech Tips

      Perform the same sliding procedure for the LH side.

    5. A01CQTHC01
      *a Protective Tape

      Using a screwdriver, tilt down the sliding roof drive cable.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Perform the same tilt down procedure for the LH side.

    6. A01CQRBC01
      *a Alignment Mark

      Slide the sliding roof drive cable and align the alignment marks.

      Tech Tips

      The illustration shown is for the RH side. Use the same procedure for the LH side.

  2. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A01CPAB

      Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.

    2. A01COGW

      Install the sunshade trim stopper.

      Tech Tips

      Use the same procedure for both sunshade trim stoppers.

  3. INSTALL REAR ROOF DRIP CHANNEL


    1. Attach the 4 guides and 2 claws to install the rear roof drip channel.

      A01CPZV

  4. INSTALL SLIDE ROOF DRAIN HOSE JOINT RH


    1. A01CN5Q

      Attach the 2 claws to install a new slide roof drain hose joint RH.

  5. INSTALL SLIDE ROOF DRAIN HOSE JOINT LH

    Tech Tips

    Use the same procedure for the RH side.

  6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. Apply MP grease around the gear of the sliding roof drive gear sub-assembly.

    2. A01CPXS

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }