POWER WINDOW REGULATOR MOTOR(for Rear Side) INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

   Note

   
   

   • Do not apply voltage to any terminals except terminals 1 and 2 to avoid damaging the pulse sensor inside the motor.

   • Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.

     Click here

   
   
   1. 

      *a	Component without harness connected (Power Window Regulator Motor Assembly LH)
      *b	Clockwise
      *c	Counterclockwise
      *d	Motor Gear

      Apply positive (+) auxiliary battery voltage to the connector terminal 2 (B).

   2. Apply negative (-) auxiliary battery voltage to the connector terminals 1 (GND) and 7 (DOWN)/10 (UP).

   3. Check that the motor gear rotates smoothly as follows.

      OK

      Measurement Condition Specified Condition Auxiliary battery positive (+) → 2 (B) Auxiliary battery negative (-): 1 (GND) (3 seconds or more) → 1 (GND) and 10 (UP) (within 1 second) → 1 (GND) (within 1 second) → 1 (GND) and 10 (UP) Motor gear rotates clockwise (UP) Auxiliary battery positive (+) → 2 (B) Auxiliary battery negative (-): 1 (GND) (3 seconds or more) → 1 (GND) and 7 (DOWN) (within 1 second) → 1 (GND) (within 1 second) → 1 (GND) and 7 (DOWN) Motor gear rotates counterclockwise (DOWN)

2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

   Note

   
   

   • Do not apply voltage to any terminals except terminals 1 and 2 to avoid damaging the pulse sensor inside the motor.

   • Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.

     Click here

   
   
   1. 

      *a	Component without harness connected (Power Window Regulator Motor Assembly RH)
      *b	Counterclockwise
      *c	Clockwise
      *d	Motor Gear

      Apply positive (+) auxiliary battery voltage to the connector terminal 2 (B).

   2. Apply negative (-) auxiliary battery voltage to the connector terminals 1 (GND) and 7 (DOWN)/10 (UP).

   3. Check that the motor gear rotates smoothly as follows.

      OK

      Measurement Condition Specified Condition Auxiliary battery positive (+) → 2 (B) Auxiliary battery negative (-): 1 (GND) (3 seconds or more) → 1 (GND) and 10 (UP) (within 1 second) → 1 (GND) (within 1 second) → 1 (GND) and 10 (UP) Motor gear rotates clockwise (UP) Auxiliary battery positive (+) → 2 (B) Auxiliary battery negative (-): 1 (GND) (3 seconds or more) → 1 (GND) and 7 (DOWN) (within 1 second) → 1 (GND) (within 1 second) → 1 (GND) and 7 (DOWN) Motor gear rotates counterclockwise (DOWN)