POWER WINDOW REGULATOR MOTOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

   Click here

3. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

   Click here

4. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

   Click here

5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

   
   

   1. 

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

   2. Loosen the nut and disconnect the cable from the auxiliary battery negative (-) terminal.

6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

7. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

8. REMOVE REAR DOOR TRIM COVER LH

   Click here

9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

10. REMOVE REAR DOOR ARMREST SET BRACKET LH

    Click here

11. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

12. REMOVE REAR DOOR GLASS RUN LH

    Click here

13. REMOVE REAR LOWER REAR DOOR WINDOW FRAME SUB-ASSEMBLY LH

    Click here

14. REMOVE REAR DOOR REAR GUIDE SEAL LH

    Click here

15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

16. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

17. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    
    

    1. 

       Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH.