POWER WINDOW REGULATOR MOTOR(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

  3. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  4. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. B002JPC

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

    2. Loosen the nut and disconnect the cable from the auxiliary battery negative (-) terminal.

  6. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  7. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  8. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  9. REMOVE FRONT DOOR TRIM COVER LH

    Click here

  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR ARMREST SET BRACKET LH

    Click here

  12. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  13. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  14. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  15. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  16. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. B002JDR

      Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH.