HEATER WATER PUMP INSTALLATION

PROCEDURE


  1. INSTALL HEATER ACCESSORY ASSEMBLY


    1. A01H5NQC01
      *a View A
      *b Heater Water Inlet Hose Paint Mark (Green)
      *c Clip installation angle (180°)

      Connect the heater water inlet hose A with the paint mark (Green) facing up and attach the clip within the area shown in the illustration.

      Note

      Do not apply excessive force to the heater water inlet hose A.

    2. A01H84JC01
      *a View A
      *b Indentation Part
      *c Clip installation angle (180°)

      Connect the heater water outlet hose A with the indentation part facing up and attach the clip within the area shown in the illustration.

      Note

      Do not apply excessive force to the heater water outlet hose A.

    3. B002L1ZC01
      *a Temporary Bolt

      Temporarily install the heater water pump assembly (heater water pump) with the 3 bolts and nut.

    4. Tighten the 3 bolts and nut in the order as shown in the illustration.

      Torque:
      Bolt A, Nut A
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
      Bolt B
      7.7 N*m  { 79 kgf*cm, 68 in.*lbf }

    5. Attach the clamp.

    6. Connect the connector.

  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. ADD ENGINE COOLANT (for Inverter Coolant)

    Click here

  6. INSPECT FOR COOLANT LEAK (for Inverter Coolant)

    Click here