REAR SEAT INNER BELT ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL REAR SEAT CENTER LAP TYPE BELT ASSEMBLY LH


    1. B002IFSC02
      *1 Protruding part

      Install the rear seat center lap type belt assembly LH with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      The anchor part of the rear seat center lap type belt assembly LH must not overlap the protruding part.

    2. B002KT0

      Install the rear seat center lap type belt assembly LH to the rear seat belt holder.

  2. INSTALL REAR SEAT INNER BELT ASSEMBLY LH


    1. Attach the 2 hooks.

    2. B002IW7C02
      *1 Protruding part

      Install the rear seat inner belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      The anchor part of the rear seat inner belt assembly LH must not overlap the protruding part.

    3. B002KV0C05
      *A for Manual Seat, w/o Seat Heater System
      *B for Manual Seat, w/ Seat Heater System
      *C for Power Seat

      w/ Seat Belt Warning System:


      1. for Manual Seat, w/o Seat Heater System:

        Attach the 2 clamps.

      2. for Manual Seat, w/ Seat Heater System:

        Attach the wire harness clamp and connect the connector.

      3. for Power Seat:

        Attach the wire harness clamp and connect the connector.

  3. INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH


    1. Attach the 2 hooks.

    2. B002JFTC02
      *1 Protruding part

      Install the rear seat inner with center belt assembly RH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      The anchor part of the rear seat inner with center belt assembly RH must not overlap the protruding part.

    3. B002HT4C05
      *A for Manual Seat, w/o Seat Heater System
      *B for Manual Seat, w/ Seat Heater System
      *C for Power Seat

      w/ Seat Belt Warning System:


      1. for Manual Seat, w/o Seat Heater System:

        Attach the 2 clamps.

      2. for Manual Seat, w/ Seat Heater System:

        Attach the wire harness clamp and connect the connector.

      3. for Power Seat:

        Attach the wire harness clamp and connect the connector.

  4. INSTALL REAR SEAT ASSEMBLY (for Manual Seat)

    Click here

  5. INSTALL REAR SEAT ASSEMBLY (for Power Seat)

    Click here