FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  4. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  5. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  6. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  8. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  9. REMOVE LAP BELT OUTER ANCHOR COVER


    1. B002HLU

      Detach the 2 claws, guide and remove the lap belt outer anchor cover.

  10. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH


    1. B002KY6

      Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly LH.

  11. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  12. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  13. REMOVE LOWER CENTER PILLAR GARNISH LH

    Click here

  14. REMOVE CENTER PILLER GARNISH ASSEMBLY LH

    Click here

  15. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    1. B002KMJ

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly LH.

    2. B002IG4C01
      *1 Protective Tape
      *2 Locking Button

      Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. B002K45

      Remove the bolt.

    4. Detach the 2 guides and remove the front seat outer belt assembly LH.

  16. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH


    1. B002IJZ

      Detach the 6 guides and remove the front shoulder belt anchor plate sub-assembly LH.

  17. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B002HMI

      Remove the 2 bolts.

    2. Disconnect the guide to remove the front shoulder belt anchor adjuster assembly.