SEAT POSITION SENSOR(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

   Click here

2. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

   Click here

3. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

   Click here

4. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing.

   Click here

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

   Click here

5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

   
   

   1. 

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

   2. Loosen the nut and disconnect the auxiliary battery negative (-) terminal.

6. REMOVE FRONT SEAT ASSEMBLY LH

   Click here

7. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

   Click here

8. REMOVE VERTICAL ADJUSTING HANDLE LH

   Click here

9. REMOVE FRONT SEAT CUSHION SHIELD LH

   Click here

10. REMOVE SEAT POSITION AIRBAG SENSOR

    
    

    1. 

       Disconnect the connector.

    2. Detach the 2 wire harness clamps.

    3. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor together with the seat slide position sensor protector.

       Note

       The "TORX" bolt must not be reused.

    4. 

       Detach the guide and remove the seat slide position sensor protector.