SIDE AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  3. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  4. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. B002JPC

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

    2. Loosen the nut and disconnect the auxiliary battery negative (-) terminal.

  6. REMOVE DOOR ARMREST COVER LH

    Click here

  7. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  8. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  9. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. REMOVE DOOR SIDE AIRBAG SENSOR LH


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the auxiliary battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    3. Disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push down the housing lock and slide the CPA. (At this time, the airbag connector cannot be disconnected yet.)

      2. Push down the housing lock again and disconnect the airbag connector.

        Note

        Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.

        B002KMAC27
        *1 Housing Lock *2 CPA
        *a CPA Upper Part - -
    4. B002HAL

      Remove the bolt.

      Note


      • Loosen the bolt while holding the door side airbag sensor LH because the door side airbag sensor LH guide is easily damaged.

      • If the door side airbag sensor LH has been dropped, replace it with a new one.

    5. Detach the guide and remove the door side airbag sensor LH.