SRS SEAT CUSHION AIRBAG ASSEMBLY(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • If the front seat cushion airbag assembly RH was deployed, replace the parts indicated in the chart below according to the specification.

    for L-Sport for F-Sport

    Front seat cushion airbag assembly

    Separate type front seat cushion cover

    Separate type front seat cushion pad

    Front seat cushion spring sub-assembly

    Front seat adjuster assembly

    Front seat cushion airbag assembly

    Front seat cushion with cover pad

    Front seat cushion spring sub-assembly

    Front seat adjuster assembly

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  3. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  4. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. B002JPC

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

    2. Loosen the nut and disconnect the auxiliary battery negative (-) terminal.

  6. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  7. REMOVE FRONT SEAT LOWER CUSHION SHIELD

    Click here

  8. REMOVE FRONT SEAT CUSHION SHIELD RH

    Click here

  9. REMOVE FRONT SEAT INNER CUSHION SHIELD RH

    Click here

  10. REMOVE SEPARATE TYPE SEAT CUSHION COVER WITH PAD (for L-Sport)

    Click here

  11. REMOVE FRONT SEAT CUSHION WITH COVER PAD LH (for F-Sport)

    Click here

  12. REMOVE FRONT SEAT CUSHION AIRBAG ASSEMBLY RH


    1. B002J93

      Detach the 3 wire harness clamps.

    2. Detach the claw and disconnect the airbag connector.

    3. B002L0D

      Detach the 3 wire harness clamps.

    4. Remove the 3 nuts and front seat cushion airbag assembly RH.

      CAUTION:


      • The nuts must not be reused.

      • When storing the front seat cushion airbag assembly RH, keep the airbag deployment side facing upward.

      • Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.