SRS SEAT CUSHION AIRBAG ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • If the cushion airbag was deployed, replace the front seat cushion airbag assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  3. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  4. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. B002JPC

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

    2. Loosen the nut and disconnect the auxiliary battery negative (-) terminal.

  6. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  7. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

    Click here

  8. REMOVE VERTICAL ADJUSTING HANDLE RH

    Click here

  9. REMOVE FRONT SEAT CUSHION SHIELD RH

    Click here

  10. REMOVE FRONT SEAT INNER CUSHION SHIELD RH

    Click here

  11. REMOVE SEPARATE TYPE SEAT CUSHION COVER WITH PAD

    Click here

  12. REMOVE FRONT SEAT CUSHION AIRBAG ASSEMBLY RH


    1. B002KK6

      Detach the wire harness clamp.

    2. Detach the claw and disconnect the airbag connector.

    3. B002L1F

      Remove the 3 nuts and front seat cushion airbag assembly RH.

      CAUTION:


      • The nuts must not be reused.

      • When storing the front seat cushion airbag assembly RH, keep the airbag deployment side facing upward.

      • Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.