AIRBAG CUT-OFF SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. Attach the 2 claws to install the airbag cut off switch cylinder sub-assembly.

  2. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. Connect the auxiliary battery negative (-) terminal and tighten the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. w/o Spare Tire:

      Attach the 2 claws to install the battery service cover.

  4. INSTALL DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  5. INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  6. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here