AIRBAG CUT-OFF SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  3. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  4. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. B002JPC

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

    2. Loosen the nut and disconnect the auxiliary battery negative (-) terminal.

  6. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  7. REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. B002HIF

      Detach the 2 claws and remove the airbag cut off switch cylinder sub-assembly.