OCCUPANT CLASSIFICATION ECU INSTALLATION

PROCEDURE

1. INSTALL OCCUPANT DETECTION ECU

   
   

   1. Attach the claw to install the occupant detection ECU.

      Note

      If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

   2. Connect the 2 connectors.

      Note

      When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.

2. INSTALL FRONT SEAT ASSEMBLY RH

   Click here

3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

   
   

   1. Connect the auxiliary battery negative (-) terminal and tighten the nut.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

4. ZERO POINT CALIBRATION AND SENSITIVITY CHECK

   Click here

5. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

6. CHECK SRS WARNING LIGHT

   Click here

7. INSTALL DECK FLOOR BOX LH (w/ Spare Tire)

   Click here

8. INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)

   Click here

9. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

   Click here