FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • If the front seat side airbag was deployed, replace the front seat airbag assembly, seatback felt, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  3. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  4. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. B002JPC

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

    2. Loosen the nut and disconnect the auxiliary battery negative (-) terminal.

  6. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  7. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  8. REMOVE VERTICAL ADJUSTING HANDLE LH

    Click here

  9. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  10. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  11. REMOVE FRONT SEAT HEADREST SUPPORT

    Click here

  12. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

    Click here

  13. REMOVE SEATBACK FELT

    Click here

  14. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH


    1. B002KX4

      for Driver Side:


      1. Detach the 4 wire harness clamps.

      2. Detach the claw and disconnect the airbag connector.

    2. B002J2E

      for Front Passenger Side:


      1. Detach the 4 wire harness clamps.

      2. Detach the claw and disconnect the airbag connector.

    3. B002HYL

      Detach the fastener and 2 wire harness clamps.

    4. B002I05

      Remove the 2 nuts and front seat airbag assembly LH.

      CAUTION:


      • The nuts must not be reused.

      • When storing the front seat airbag assembly LH, keep the airbag deployment side facing upward.

      • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.