CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
PROCEDURE
INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the auxiliary battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.
| *1 | Connector Lock |
Connect the airbag connector and push in the connector lock.
Note
When connecting any airbag connector, take care not to damage the airbag wire harness.
Attach the 2 hooks to set the lower No. 1 instrument panel airbag assembly.
Install the 4 bolts.
Note
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
INSTALL REAR CONSOLE ARMREST ASSEMBLY
INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
INSTALL INSTRUMENT SIDE PANEL LH
INSTALL COWL SIDE TRIM BOARD LH
INSTALL DOOR SCUFF PLATE ASSEMBLY LH
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Connect the auxiliary battery negative (-) terminal and tighten the nut.
w/o Spare Tire:
Attach the 2 claws to install the battery service cover.
INSTALL DECK FLOOR BOX LH (w/ Spare Tire)
INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)
INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)
PERFORM DIAGNOSTIC SYSTEM CHECK
CHECK SRS WARNING LIGHT