KNEE AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

   Click here

2. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

   Click here

3. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

   Click here

4. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing.

   Click here

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

   Click here

5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

   
   

   1. 

      w/o Spare Tire:

      Detach the 2 claws and remove the battery service cover.

   2. Loosen the nut and disconnect the auxiliary battery negative (-) terminal.

6. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

   Click here

7. REMOVE COWL SIDE TRIM BOARD LH

   Click here

8. REMOVE INSTRUMENT SIDE PANEL LH

   Click here

9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

10. REMOVE REAR CONSOLE ARMREST ASSEMBLY

    Click here

11. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

12. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

13. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

14. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    CAUTION:

    When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.

    
    

    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the auxiliary battery negative (-) terminal.

       CAUTION:

       Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    3. 

       Remove the 4 bolts.

    4. Detach the 2 hooks and remove the lower No. 1 instrument panel airbag assembly.

       Note

       When removing the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.

    5. 

       *1	Connector Lock
       	Protective Tape

       Using a screwdriver, pull up and release the connector lock and disconnect the airbag connector.

       Note

       When disconnecting any airbag connector, take care not to damage the airbag wire harness.

       Tech Tips

       Tape the screwdriver tip before use.