AIRBAG SYSTEM DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / SRS Airbag / Data List.

    5. According to the display on the GTS, read the Data List.


      Body Electrical > SRS Airbag > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Driver Seat Position Driver Seat Position For ward, Bk ward or Fail

      For ward: Seat position is forward

      BK ward: Seat position is backward

      Fail: Failure is detected

      		 -
      Left side Buckle SW Front seat belt LH Unset, Set or NG

      Unset: Front seat belt LH not fastened

      Set: Front seat belt LH fastened

      NG: Data is not determined

      		 for RHD: Perform the inspection while sitting in the front passenger side seat.
      Right side Buckle SW Front seat belt RH Unset, Set or NG

      Unset: Front seat belt RH not fastened

      Set: Front seat belt RH fastened

      NG: Data is not determined

      		 for LHD: Perform the inspection while sitting in the front passenger side seat.
      Display Type Information Display Type Information LR or DP

      LR: Display is indicated by LH / RH

      DP: Display is indicated by Driver Side / Passenger Side

      		 -
      Number of Past DTC Number of Past DTCs Min.: 0, Max.: 255 0 -