CLOCK SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedures to troubleshoot the clock system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

    Result
    Proceed to
    NEXT

    NEXT

  3. INSPECT AUXILIARY BATTERY VOLTAGE


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard voltage
      11 to 14 V

      Tech Tips

      If the battery voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK NAVIGATION SYSTEM*


    1. Using the GTS, check if the navigation system is functioning normally.


      1. Check for DTCs and note any codes that are output.

        Click here


        Body Electrical > Navigation System > Trouble Codes

      2. Clear the DTCs.

        Click here


        Body Electrical > Navigation System > Clear DTCs

      3. Recheck for DTCs by simulating the operation indicated by the DTCs.

        Click here


        Body Electrical > Navigation System > Trouble Codes
      OK
      DTCs are not output.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO NAVIGATION SYSTEM Click here

    OK

  5. PROBLEM SYMPTOMS TABLE

    Tech Tips

    Refer to Problem Symptoms Table.

    Click here

    Result
    Result Proceed to
    Fault is not listed in Problem Symptoms Table. A
    Fault is listed in Problem Symptoms Table. B

    B

    PERFORM TROUBLESHOOTING BASED ON PROBLEM SYMPTOM Click here

    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING


    1. Terminals of ECU

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  7. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  8. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END