HEADUP DISPLAY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)


    1. Disable the autoaway/return function by changing the customize parameter.

      Click here

      CAUTION:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the power switch off.

  2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  4. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  5. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work.

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here


    1. B002JPC

      w/o Spare tire:

      Detach the 2 claws and remove the battery service cover.

  7. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  8. REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY


    1. B002J1F

      Remove the 3 screws and No. 1 heater to register duct sub-assembly.

  9. REMOVE METER MIRROR SUB-ASSEMBLY (HEADUP DISPLAY)


    1. B002JM1C07
      *a Connector
      *b Screw

      Disconnect the connector.

    2. Remove the 4 screws and meter mirror sub-assembly (headup display).