ROOM LIGHT INSPECTION

PROCEDURE


  1. INSPECT SPOT LIGHT ASSEMBLY (ROOM LIGHT)


    1. Inspect the room light.


      1. A01CPNOC05
        *a

        Component without harness connected

        (Spot Light Assembly (Room Light))

        Apply battery voltage to the connector and check the light illumination condition.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → 1 (B)

        Battery negative (-) → 5 (GND1)

        		 Room light switch on Room light illuminates

        If the result is not as specified, replace the spot light assembly (room light).

    2. A01CPNOC06
      *a

      Component without harness connected

      (Spot Light Assembly (Room Light))

      Inspect the room light (for Door-linked).


      1. Apply battery voltage to the connector and check the light illumination condition.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → 1 (B)

        Battery negative (-) → 4 (CTY)

        		 Always Room light illuminates

        If the result is not as specified, replace the spot light assembly (room light).

    3. A01CPNOC07
      *a

      Component without harness connected

      (Spot Light Assembly (Room Light))

      Inspect the switch illumination.


      1. Apply battery voltage to the connector and check the light illumination condition.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → 2 (ILLB)

        Battery negative (-) → 5 (GND1)

        		 Always Switch illumination illuminates

        If the result is not as specified, replace the spot light assembly (room light).