PERSONAL LIGHT INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY (PERSONAL LIGHT)


    1. A01CRO3C09
      *a

      Component without harness connected

      (Map Light Assembly (Personal Light))

      Inspect the front map light.


      1. Apply battery voltage to the connector and check the light illumination condition.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → T6 - 4 (+B1)

        Battery negative (-) → T7 - 20 (GND9)

        		 Front map light LH operated Front map light LH illuminates
        Front map light RH operated Front map light RH illuminates

        If the result is not as specified, replace the map light assembly (personal light).

    2. A01COLMC04
      *a

      Component without harness connected

      (Map Light Assembly (Personal Light))

      Inspect the front dome light.


      1. Apply battery voltage to the connector and check the light illumination condition.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → T6 - 4 (+B1)

        Battery negative (-) → T6 - 9 (CTY)

        		 Always Front dome light illuminates

        Battery positive (+) → T6 - 4 (+B1)

        Battery negative (-) → T6 - 10 (RIFL)

        If the result is not as specified, replace the map light assembly (personal light).

    3. A01CRO3C10
      *a

      Component without harness connected

      (Map Light Assembly (Personal Light))

      Inspect internal circuit.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        T6 - 4 (+B1) - T7 - 14 (RIFR) Always Below 1 Ω
        T7 - 10 (RLMP) - T7 - 2 (GND9) Always Below 1 Ω

        If the result is not as specified, replace the map light assembly (personal light).

    4. B002K60C03
      *a

      Component without harness connected

      (Map Light Assembly (Personal Light))

      Inspect the door switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        T7 - 18 (DOOR) - T7 - 20 (GND9) Door switch off 1 kΩ or higher

        If the result is not as specified, replace the map light assembly (personal light).

    5. A01COLMC05
      *a

      Component without harness connected

      (Map Light Assembly (Personal Light))

      Inspect the intrusion sensor cancel switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        T6 - 22 (SOFF) - T6 - 19 (GND) Intrusion sensor cancel switch not pushed 1 kΩ or higher

        If the result is not as specified, replace the map light assembly (personal light).

    6. A01COLMC06
      *a

      Component without harness connected

      (Map Light Assembly (Personal Light))

      Inspect the switch illumination.


      1. Apply battery voltage to the connector and check the light illumination condition.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → T6 - 16 (ILLB)

        Battery negative (-) → T6 - 8 (LILL)

        		 Always Switch illumination illuminates

        If the result is not as specified, replace the map light assembly (personal light).