ELECTRICAL KEY OSCILLATOR(for Front Floor) INSTALLATION

PROCEDURE

1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

   Note

   Do not reuse dropped or damaged parts.

   
   

   1. Attach the clamp and install No. 1 indoor electrical key antenna assembly.

   2. Connect each connector.

2. INSTALL SHIFT LEVER ASSEMBLY

   Click here

3. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

   Click here

4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

   Click here

6. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

7. INSTALL NO. 1 SWITCH HOLE BASE

   Click here

8. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

10. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

11. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

12. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

13. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

14. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

15. INSTALL UPPER REAR CONSOLE PANEL

    Click here

16. INSTALL CONSOLE ARMREST ASSEMBLY

    Click here

17. INSTALL COWL SIDE TRIM BOARD RH (for RHD)

    Click here

18. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

    Click here

19. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

20. INSTALL DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

21. INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

22. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

23. INSTALL DECK BOARD ASSEMBLY

    Click here