ELECTRICAL KEY OSCILLATOR(for Front Floor) REMOVAL

PROCEDURE

1. REMOVE DECK BOARD ASSEMBLY

   Click here

2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

   Click here

3. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

   Click here

4. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

   Click here

5. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

   Click here

6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

7. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

   Click here

8. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

   Click here

9. REMOVE CONSOLE ARMREST ASSEMBLY

   Click here

10. REMOVE UPPER REAR CONSOLE PANEL

    Click here

11. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

12. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

13. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

14. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

15. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

16. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

17. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

18. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

19. REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

20. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

21. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

22. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

    Click here

23. REMOVE SHIFT LEVER ASSEMBLY

    Click here

24. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

    Note

    Do not reuse dropped or damaged parts.

    
    

    1. 

       Disconnect the connector.

    2. Detach the clamp and remove the No. 1 indoor electrical key antenna assembly.