CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
REMOVE DECK BOARD ASSEMBLY
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)
REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)
REMOVE DECK FLOOR BOX LH (w/ Spare Tire)
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
REMOVE FRONT DOOR TRIM COVER LH
REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
REMOVE FRONT DOOR ARMREST SET BRACKET LH
REMOVE FRONT DOOR SERVICE HOLE COVER LH
REMOVE FRONT DOOR GLASS RUN LH
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY LH (for Driver Side)
REMOVE FRONT DOOR LOCK ASSEMBLY LH
Disconnect the connector.
| *A | w/o Double Locking System | *B | w/ Double Locking System |
| *1 | Front Door Lock Open Rod LH | - | - |
|
Downward | - | - |
Using a T30 "TORX" socket wrench, remove the 3 screws.
Slide the front door lock assembly LH downward, and remove the front door lock assembly LH and cables as a unit.
REMOVE DOOR LOCK WIRING HARNESS SEAL
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
Remove the door lock wiring harness seal from the front door lock assembly LH.
REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY LH (w/o Double Locking System)
Using a screwdriver, detach the 2 claws.
Detach the 2 guides and remove the front door lock cover sub-assembly LH from the front door lock assembly LH.
REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
w/o Double Locking System:
Detach the clamp and remove the front door lock remote control cable assembly LH from the front door lock assembly LH.
w/ Double Locking System:
Detach the clamp and remove the front door lock remote control cable assembly LH from the front door lock assembly LH.
REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
w/o Double Locking System:
Detach the clamp and remove the front door inside locking cable assembly LH from the front door lock assembly LH.
w/ Double Locking System:
Using a screwdriver, detach the claw.
Detach the 2 guides and open the cover.
Detach the clamp and remove the front door inside locking cable assembly LH from the front door lock assembly LH.