NETWORK GATEWAY ECU(for RHD) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

   Click here

2. REMOVE DECK BOARD ASSEMBLY

   Click here

3. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

   Click here

4. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

   Click here

5. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

   Click here

6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Click here

7. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

   Tech Tips

   Use the same procedure described for the LH side.

   Click here

8. REMOVE COWL SIDE TRIM BOARD RH

   Tech Tips

   Use the same procedure described for the LH side.

   Click here

9. REMOVE REAR CONSOLE ARMREST ASSEMBLY

   Click here

10. REMOVE UPPER REAR CONSOLE PANEL

    Click here

11. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

12. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

13. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

14. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

15. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

16. REMOVE ECU INTEGRATION BOX RH

    Click here

17. REMOVE NETWORK GATEWAY ECU

    
    

    1. Detach the 2 claws and remove the network gateway ECU.