PARKING ASSIST ECU INSTALLATION

PROCEDURE


  1. INSTALL PARKING ASSIST ECU


    1. A0000N5C02
      *A w/ Panoramic View Monitor System
      *B w/o Panoramic View Monitor System
      B002HVY Nut
      B002I10 Connector

      Temporarily install nut (A) so that the nut cannot fall, but do not tighten it.

    2. Connect the 3 connectors.

    3. Insert nut (A) into the hole in the body and slide downward to temporarily install the parking assist ECU.

    4. Temporarily install the 2 nuts.

    5. w/ Panoramic View Monitor System:


      1. Install the parking assist ECU with the 3 nuts.

        Tech Tips

        Tighten the nuts in the order shown in the illustration.

        Torque:
        5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    6. w/o Panoramic View Monitor System:


      1. Install the parking assist ECU with the 2 nuts.

        Tech Tips

        Tighten the nuts in the order shown in the illustration.

        Torque:
        5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH

    Click here

  3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  5. INSTALL ROPE HOOK ASSEMBLY

    Click here

  6. INSTALL UPPER DECK TRIM SIDE BOARD RH

    Click here

  7. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

    Click here

  8. INSTALL REAR FLOOR FINISH PLATE

    Click here

  9. INSTALL REAR SEAT ASSEMBLY


    1. for Manual Seat:

      Click here

    2. for Power Seat:

      Click here

  10. PERFORM PANORAMIC VIEW MONITOR SYSTEM CALIBRATION

    Click here