AUDIO AND VISUAL SYSTEM(for 8 Speakers) Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

A0001EIE01

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the I119 radio receiver assembly connector.

    2. Disconnect the P33 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I119-2 (RL+) - P33-15 (II1+) Always Below 1 Ω
      I119-6 (RL-) - P33-14 (II1-) Always Below 1 Ω
      P33-18 (SLD1) - Body ground Always 10 kΩ or higher
      I119-2 (RL+) or P33-15 (II1+) - Body ground Always 10 kΩ or higher
      I119-6 (RL-) or P33-14 (II1-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR