PARKING ASSIST MONITOR SYSTEM DTC CHECK / CLEAR


  1. CHECK DTC


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Parking Assist Camera / Trouble Codes.


      Chassis > Parking Assist Camera > Trouble Codes
    5. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.


      Body Electrical > Navigation System > Trouble Codes
    6. Check for DTCs, and then write them down.

    7. Check for DTCs.

      Click here

      Note


      • C1622 is output from the radio receiver assembly. Therefore, if C1622 is output, proceed to the Problem Symptoms Table for the relevant systems.

        Refer to Audio and Visual System (for 8 Inch Display)*1

        Click here

        Refer to Audio and Visual System (for 10.3 Inch Display)*2

        Click here

        Refer to Navigation System*3

        Click here

      • The radio receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

        System Proceed to
        Audio and Visual System (for 8 Inch Display)*1

        Click here

        Audio and Visual System (for 10.3 Inch Display)*2

        Click here

        Navigation System*3

        Click here


      • *1: w/ Audio and Visual System (for 8 Inch Display)

      • *2: w/ Audio and Visual System (for 10.3 Inch Display)

      • *3: w/ Navigation System

  2. CLEAR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Parking Assist Camera / Trouble Codes.


      Chassis > Parking Assist Camera > Clear DTCs
    5. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.


      Body Electrical > Navigation System > Clear DTCs
    6. Clear the DTCs.