TIRE PRESSURE WARNING INITIATOR DRIVER INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE MONITOR INITIATOR DRIVER

   
   

   1. Attach the 2 claws to install the tire pressure monitor initiator driver.

2. INSTALL ECU INTEGRATION BOX RH

   
   

   1. Install the ECU integration box RH with the 2 nuts and bolt.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   2. Connect the connectors.

   3. Attach the 4 clamps.

3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

   Click here

4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

6. INSTALL DECK FLOOR BOX LH

   Click here

7. INSTALL REAR DECK FLOOR BOX

   Click here

8. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

   Click here

9. INSTALL DECK BOARD ASSEMBLY

   Click here

10. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here