TIRE PRESSURE WARNING INITIATOR DRIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

  4. REMOVE REAR DECK FLOOR BOX

    Click here

  5. REMOVE DECK FLOOR BOX LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  9. REMOVE ECU INTEGRATION BOX RH


    1. B002JS7

      Disconnect the connectors.

    2. Detach the 4 clamps.

    3. B002HQ8C01
      B002HVY Nut
      B002I10 Bolt

      Remove the 2 nuts, bolt and ECU integration box RH.

  10. REMOVE TIRE PRESSURE MONITOR INITIATOR DRIVER


    1. B002HI3

      Detach the 2 claws and remove the tire pressure monitor initiator driver.